This is a fully open-source car datalogger that reads engine data using the OBD2 interface in real time and stores it on an SD card. It also stores GPS data. All communication is done directly by the MCU without a translator chip like ELM327 or STN1110. The datalogger supports all CAN and K-Line OBD2 protocols. All hardware fits into an off-the-shelf OBD2 connector enclosure.
This project is available on Github.
All modern cars have an OBD2 diagnostic connector that allows reading many engine and drivetrain parameters like RPM, vehicle speed, temperatures etc.
Most of car interfaces use a special protocol translating chip like ELM327 or STN1110 to convert different vehicle protocols (that depend on the age and brand of the car) into an easier to use serial protocol with AT-commands.
I wanted to build a datalogger that would fit into a OBD2 connector. There was no space to fit my microcontroller and another chip to do protocol conversion, so I investigated and reverse-engineered the most common OBD2 protocols to be able to implement them directly on my MCU.
Continue reading “Reading OBD2 data without ELM327, part 1 – CAN”